• New
NOCO AIR20 · 100 PSI clamp compressor | telebaterias.com
NOCO AIR20 · 100 PSI clamp compressor | telebaterias.com
NOCO AIR20 · 100 PSI clamp compressor | telebaterias.com
NOCO AIR20 · 100 PSI clamp compressor | telebaterias.com
NOCO AIR20 · 100 PSI clamp compressor | telebaterias.com

AIR20 by NOCO: 12V clamp-on compressor, 100 PSI and 47 L/min

NOCO

The biggest of the AIR range: it skips the 12 V socket and clamps onto the battery on a 6 m lead. Up to 100 PSI and 35-inch tyres.

6.9 bar / 100 PSI maximum | 47 L/min, 280 W motor | Battery clamps, 6 m lead | Tyres up to 35 inches

Free quote, no obligation

Request a quote for your AIR20 by NOCO: 12V clamp-on compressor, 100 PSI and 47 L/min

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

insert_link

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price
insert_link

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

AIR20 by NOCO: 12V clamp-on compressor, 100 PSI and 47 L/min

Will the lead reach the rear wheels of a motorhome or a 4x4? At 6 m it will, and since it clamps directly onto the 12 V battery it does not rely on the socket fuse. It reaches 6.9 bar (100 PSI), moves 47 L/min and takes a 205/65R16 from 0 to 40 PSI in about 2.5 minutes.

Pressure is programmable from 15 to 100 PSI with auto shut-off and memory; manual mode covers anything under 15 PSI.

Supplied with a Presta adapter, ball needle, inflatables nozzle and microfibre bag. 60-lumen LED torch with SOS, IP55 protection.

Before you order, check

  • ›  You need access to a 12 V battery for the clamps.
  • ›  Check your tyres are no larger than 35 inches.
  • ›  If the socket and 60-80 PSI are enough, the AIR10 or AIR15 are lighter.
  • ›  Respect the 15-minute duty cycle at 30 PSI.
  • ›  Unsure it is worth it? We will confirm by phone.

Features

  • ›  280 W motor: 18 A working, 22 A peak, 25 A fuse
  • ›  6.9 bar (100 PSI) pressure and 47 L/min airflow
  • ›  Tops up from 35 to 40 PSI in under 25 seconds
  • ›  Works 15 minutes at 30 PSI, rests 45
  • ›  6 m power lead (14 AWG) with clamps
  • ›  3.09 kg; 215 x 74 x 159 mm

In the box

  • ›  AIR20 compressor with 0.9 m braided hose and 6 m cable with clamps
  • ›  Presta valve adapter
  • ›  Needle adapter for balls
  • ›  Inflatable toy adapter
  • ›  Microfibre storage bag
  • ›  User guide and warranty

Technical data

Voltage12 V
Motor power280 W
Maximum pressure6.89 bar / 689 kPa (100 PSI)
Maximum airflow at 0 PSI47 L/min (1.66 CFM)
Settable pressure1.0-6.9 bar (15-100 PSI)
Inflation time 0-40 PSI2.5 min ±10% (205/65R16, 13.8 V)
Top-up from 35 to 40 PSIUnder 25 s
Working current18 A
Maximum current draw22 A
Fuse25 A
Duty cycle15 min at 30 PSI / 45 min rest
Manual mode duty cycle5 min / 30 min rest
Power supplyClamps to 12 V battery
Power cable6 m (14 AWG)
Hose0.9 m, braided
TyresUp to 35 inches
Torch60 lumens
ProtectionIP55
CoolingNatural convection
Operating temperature-20 °C to 50 °C
Storage temperature-20 °C to 50 °C
Dimensions (W x D x H)215 x 74 x 159 mm
Weight3.09 kg

  • Brand
    NOCO
  • Reference
    TB-NOCO-AIR20
  • EAN13
    1210000623041
  • MPN
    AIR20

noco-air20-ficha-tecnica.pdf

Download (1.03MB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Back to top