GCP1 by NOCO: panel-mount power inlet with 40.6 cm lead
A power inlet for the bodywork: plug the extension in outside, and inside the 40.6 cm lead feeds your charger. No hard wiring.
15 A, 14 AWG copper lead | 40.6 cm integrated lead | 51 mm mounting hole | Snap cover with gasket
GCP1 by NOCO: panel-mount power inlet with 40.6 cm lead
Can I charge the boat battery without opening hatches or feeding cables through? With the GCP1 you can: it sits flush in the hull, bodywork or trailer, and inside its 40.6 cm lead ends in a single AC outlet where your battery charger or engine block heater stays connected.
It handles 15 A on 14 AWG copper cable. Fitting takes four steps: drill 51 mm, insert, secure with the 3 self-tapping screws (fine for fibreglass, wood, plastic or metal) and connect. The snap cover with rubber gasket seals it.
Before you order, check
- › Measure where the charger goes: the inside lead is 40.6 cm; for more, there are the GCP1E (1.83 m) and GCP1EX (3.66 m).
- › Whatever you connect should not exceed 15 A.
- › You need room for a 51 mm hole.
- › Questions about fitting it? Call us.
Features
- › AC inlet with 40.6 cm (16 in) lead and a single outlet
- › Rated 15 A, 14 AWG copper conductor
- › For chargers, block heaters and exterior power points
- › No hard wiring, fits a 51 mm hole
- › Weighs 0.21 kg; cover and 3 screws included
In the box
- › GCP1 port plug with 40.6 cm cord
- › Pressure-fit cap
- › 3 self-tapping screws
Technical data
| Rated current | 15 A |
|---|---|
| AC output | Single |
| Cord length | 40.6 cm (16 in) |
| Cable gauge | 14 AWG, copper |
| Mounting hole | 51 mm (2") |
| Weight | 0.21 kg |
-
Brand
-
ReferenceTB-NOCO-GCP1
-
MPNGCP1