GCP1E by NOCO: panel-mount power inlet with 1.83 m lead

The same flush inlet as the GCP1 but with 1.83 m (6 ft) of inner lead, for when the charger sits further from the panel.

1.83 m inner lead | 15 A, 14 AWG copper | 51 mm mounting hole | Gasket-sealed cover

Free quote, no obligation

Request a quote for your GCP1E by NOCO: panel-mount power inlet with 1.83 m lead

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

GCP1E by NOCO: panel-mount power inlet with 1.83 m lead

Charger in the motorhome locker and inlet on the side wall? The GCP1E covers that distance: its integrated lead is 1.83 m (6 ft) long and ends in a single AC outlet for the battery charger or an engine block heater.

Rated 15 A with a 14 AWG copper conductor. No hard wiring needed: 51 mm hole, push in, three self-tapping screws and done, on fibreglass, wood, plastic or metal. A snap cover with rubber gasket keeps it sealed.

Before you order, check

  • ›  Work out the distance: 1.83 m of inner lead. For less, the GCP1 (40.6 cm); for more, the GCP1EX (3.66 m).
  • ›  Keep whatever you connect under 15 A.
  • ›  Choose a surface with room for the 51 mm hole.
  • ›  We can help you pick the length by phone.

Features

  • ›  AC inlet with 1.83 m (6 ft) lead and single outlet
  • ›  14 AWG copper cable for 15 A
  • ›  Intended for battery chargers and engine heaters
  • ›  4-step fitting in a 51 mm hole
  • ›  Snap cover and gasket; weighs 0.41 kg

In the box

  • ›  GCP1E port plug with 1.83 m cord
  • ›  Pressure-fit cap
  • ›  3 self-tapping screws

Technical data

Rated current15 A
AC outputSingle
Cord length1.83 m (6 ft)
Cable gauge14 AWG, copper
Mounting hole51 mm (2")
Weight0.41 kg

  • Brand
  • Reference
    TB-NOCO-GCP1E
  • MPN
    GCP1E

noco-gcp1e-ficha-tecnica.pdf

Download (1.72MB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Loading...
Back to top