GEN5X1 by NOCO: 12V 5A on-board charger, 1 bank, IP68

Got a single 12 V battery on your boat? The GEN5X1 bolts in on board, shrugs off water (IP68) and charges it at 5 A, whether it is lead-acid or lithium with a BMS.

One 5 A output at 12 V | Batteries up to 120 Ah | Waterproof to IP68 | Lead-acid and BMS lithium

Free quote, no obligation

Request a quote for your GEN5X1 by NOCO: 12V 5A on-board charger, 1 bank, IP68

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

GEN5X1 by NOCO: 12V 5A on-board charger, 1 bank, IP68

Will it work on my boat battery if it is permanently installed? That is exactly the job: the GEN5X1 mounts on board in any orientation, even upside down, and its fully sealed IP68 housing copes with the marine environment. It has one 5 A output for a 12 V battery of up to 120 Ah.

What if my battery is lithium? There is a 12 V lithium mode for batteries with a BMS, LiFePO4 included, plus 12V and AGM modes for lead-acid. A deeply drained battery is detected from 1 V, and a force mode covers anything lower. You can leave it plugged in permanently and it remembers the last mode used.

Before you order, check

  • ›  Your battery is 12 V: it will not charge 6 V or 24 V systems.
  • ›  Its capacity: 5 A suits batteries up to 120 Ah; above that, look at the GENPRO10X1 (10 A, up to 230 Ah).
  • ›  How many batteries you need to charge: this one has 1 bank; the GEN5X2 has 2 and the GEN5X3 has 3.
  • ›  The chemistry: lead-acid (wet, gel, MF, calcium, EFB, AGM) or 12 V lithium with BMS.
  • ›  Not sure about your setup? Give us a call and we will confirm the right model before you order.

Features

  • ›  One 5 A output for a single 12 V battery of up to 120 Ah.
  • ›  12 V lead-acid (wet, gel, MF, calcium, EFB, AGM) and 12 V lithium with BMS, LiFePO4 included.
  • ›  Modes: 12V, AGM, lithium, repair and force.
  • ›  Detects batteries from 1 V; force mode handles anything below that.
  • ›  Sealed IP68 housing, operating from -20 °C to +40 °C.
  • ›  Mounts in any orientation with an anti-vibration backing; DC cable of about 1.83 m.
  • ›  From 50 % discharge, a 100 Ah battery takes around 15 h.

In the box

  • ›  GEN5X1 on-board charger
  • ›  2 x #8 27 mm self-tapping screws
  • ›  User guide and warranty

Technical data

Mains input voltage100-240 VAC, 50-60 Hz
Output power72 W max.
Charging banks1
Charging current5 A (12 V)
Battery voltage12 V
Battery chemistriesLead-acid (wet, gel, MF, calcium, EFB, AGM) and 12V lithium with BMS (incl. LiFePO4)
Battery capacityUp to 120 Ah; maintains all battery sizes
Charging modes12V, 12V AGM, 12V Lithium, Repair and Force
Low-voltage detection1 V (Force Mode: 0 V)
Back current drain< 0.5 mA
Operating temperature-20 °C to +40 °C
Housing protectionIP68
CoolingNatural convection
DC cable lengthapprox. 1.83 m
Approx. charging time (50% depth of discharge)20 Ah: 3 h · 40 Ah: 6 h · 100 Ah: 15 h · 120 Ah: 18 h
Dimensions (L x W x H)117 x 74 x 48 mm
Weight0.84 kg

  • Brand
  • Reference
    TB-NOCO-GEN5X1
  • MPN
    GEN5X1

noco-gen5x1-ficha-tecnica.pdf

Download (2.32MB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Loading...
Back to top