• New
NOCO GENPRO10X2 · 2 × 10A | telebaterias.com
NOCO GENPRO10X2 · 2 × 10A | telebaterias.com
NOCO GENPRO10X2 · 2 × 10A | telebaterias.com
NOCO GENPRO10X2 · 2 × 10A | telebaterias.com
NOCO GENPRO10X2 · 2 × 10A | telebaterias.com

GENPRO10X2 by NOCO: 12V 20A on-board charger, 2 banks of 10A

NOCO

Two large 12 V batteries and one fixed charger: the GENPRO10X2 gives each one 10 A separately and accepts up to 230 Ah per bank.

2 banks of 10 A (20 A total) | Up to 230 Ah per bank | Isolated, independent outputs | Sealed IP68, 300 W

Free quote, no obligation

Request a quote for your GENPRO10X2 by NOCO: 12V 20A on-board charger, 2 banks of 10A

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

insert_link

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price
insert_link

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

GENPRO10X2 by NOCO: 12V 20A on-board charger, 2 banks of 10A

Starting and house batteries bigger than 120 Ah? This is where the GEN5X2 runs out and the GENPRO10X2 takes over: two isolated banks of 10 A each, 20 A in total, charging two 12 V batteries of up to 230 Ah separately.

Can each bank run a different chemistry? Yes: every output works independently and accepts lead-acid (wet, gel, MF, calcium, EFB, AGM) or 12 V lithium with a BMS. It adds a repair mode, a force mode below 1 V and temperature compensation, and its IP68 housing mounts in any position.

Before you order, check

  • ›  We are talking about 12 V batteries.
  • ›  How many: 2 banks; for 3 or 4 batteries there are the GENPRO10X3 and GENPRO10X4.
  • ›  The size: if no battery exceeds 120 Ah, the GEN5X2 (2 × 5 A) will also do.
  • ›  The space: 206 × 147 × 74 mm, 3.27 kg.
  • ›  Tell us about your setup over the phone and we will confirm the model.

Features

  • ›  2 isolated banks of 10 A each, 20 A in total.
  • ›  12 V batteries up to 230 Ah per bank.
  • ›  Each bank independently accepts lead-acid or 12 V lithium with BMS.
  • ›  A 100 Ah battery at 50 % discharge takes about 7 h per bank.
  • ›  12V, AGM, lithium, repair and force modes.
  • ›  Sealed to IP68, -20 °C to +40 °C; DC cable of about 1.83 m.
  • ›  300 W output; 206 × 147 × 74 mm and 3.27 kg.

In the box

  • ›  GENPRO10X2 on-board charger
  • ›  2 x #8 27 mm self-tapping screws
  • ›  User guide and warranty

Technical data

Mains input voltage100-240 VAC, 50-60 Hz
Output power300 W max.
Charging banks2
Current per bank10 A (12 V)
Total charging current20 A
Battery voltage12 V
Battery chemistriesLead-acid (wet, gel, MF, calcium, EFB, AGM) and 12V lithium with BMS (incl. LiFePO4)
Battery capacityUp to 230 Ah per bank; maintains all battery sizes
Charging modes12V, 12V AGM, 12V Lithium, Repair and Force
Low-voltage detection1 V (Force Mode: 0 V)
Back current drain< 0.5 mA
Operating temperature-20 °C to +40 °C
Housing protectionIP68
CoolingNatural convection
DC cable lengthapprox. 1.83 m
Approx. charging time (50% depth of discharge)20 Ah: 1.5 h · 40 Ah: 3 h · 100 Ah: 7 h · 230 Ah: 17.3 h
Dimensions (L x W x H)206 x 147 x 74 mm
Weight3.27 kg

  • Brand
    NOCO
  • Reference
    TB-NOCO-GENPRO10X2
  • MPN
    GENPRO10X2

noco-genpro10x2-ficha-tecnica.pdf

Download (2.39MB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Back to top