GBC013 by NOCO: EVA case for Boost GB20, GB30 and GB40 jump starters

A thermoformed EVA case shaped for NOCO's small Boost units, with a bay for the jump starter and pockets for clamps and leads.

For Boost GB20, GB30 and GB40 | Rubberised thermoformed EVA | Velvet-lined interior | 258 x 146 x 97 mm

Free quote, no obligation

Request a quote for your GBC013 by NOCO: EVA case for Boost GB20, GB30 and GB40 jump starters

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

GBC013 by NOCO: EVA case for Boost GB20, GB30 and GB40 jump starters

Where do I keep the GB40 so it does not roll around the boot? In the GBC013: the made-to-fit case for the NOCO Boost GB20, GB30 and GB40. The outside is thermoformed EVA with a rubberised, water-repellent finish that stands up to knocks and dust.

Inside, a moulded tray lined with black velvet holds the jump starter, while semi-rigid pockets take the clamps or an extension lead. It closes with a reinforced reverse-coil zip and has a built-in handle. Jump starter not included.

Before you order, check

  • ›  Check that your jump starter is a GB20, GB30 or GB40.
  • ›  For the GB50 the case is the GBC017; for the GB70, the GBC014.
  • ›  Sold without the jump starter.
  • ›  Not sure? We will confirm before you order.

Features

  • ›  Made for the NOCO Boost GB20, GB30 and GB40 jump starters
  • ›  Lightweight thermoformed EVA shell with water-resistant rubberised surface
  • ›  Moulded tray lined in black velvet
  • ›  Reinforced semi-rigid pockets for clamps and accessories
  • ›  Reinforced zip, integrated handle and over-moulded pulls; 258 x 146 x 97 mm

Technical data

CompatibilityNOCO Boost GB20, GB30, GB40
MaterialThermoformed EVA, rubberised finish
InteriorMoulded tray with velvet lining
ClosureHeavy-duty reverse coil zip
Dimensions258 x 146 x 97 mm
Jump starter includedNo (sold separately)

  • Brand
  • Reference
    TB-NOCO-GBC013
  • EAN13
    1210000617279
  • MPN
    GBC013

noco-gbc013-ficha-tecnica.pdf

Download (815.11KB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Loading...
Back to top