T11 by Lemania Energy: 12/24V battery tester with printer

The workshop tester that gives you the result on paper: it checks the battery at 12 volts and the starter and alternator at 12 or 24 volts.

Prints the report | Battery at 12 volts | Starter and alternator, 12 or 24 | Lead-acid & lithium to 2000 CCA | Case included

Free quote, no obligation

Request a quote for your T11 by Lemania Energy: 12/24V battery tester with printer

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

T11 by Lemania Energy: 12/24V battery tester with printer

Can I hand the customer a printed diagnosis? With the Lemania Energy T11, yes: it has its own printer and, if you would rather save paper, it also passes the data over USB or via a QR code.

What does it check? The battery at 12 volts, the starter motor and alternator at both 12 and 24 volts, and the ground at 12 volts. It reads lead-acid and lithium between 100 and 2000 CCA, understands SAE, DIN, EN, IEC, JIS, BCI, GB, CA, MCA and CCA, and spots bad cells.

It needs no battery of its own, survives a reversed hook-up and has 175 cm of cable. It takes up 230 x 100 x 40 mm, weighs 0.72 kg and lives in its case.

Before you order, check

  • ›  The battery is tested at 12 volts; starter and alternator also at 24.
  • ›  Do your batteries fall between 100 and 2000 CCA?
  • ›  Need paper? If not, the T3 or T4 pass results by QR.
  • ›  In the box: the T11 and its case.
  • ›  We will help you by phone to pick the right tester for your workshop.

Features

  • ›  Built-in printer, plus USB and QR code to pass on results.
  • ›  Battery and ground at 12 volts; starter and alternator at 12 or 24 volts.
  • ›  Reads lead-acid and lithium from 100 up to 2000 CCA.
  • ›  Standards: SAE, DIN, EN, IEC, JIS, BCI, GB, CA, MCA and CCA.
  • ›  Spots cells in poor condition.
  • ›  LCD screen and touch controls; runs without an internal battery.
  • ›  Withstands reversed connection; 175 cm cable; 0.72 kg; comes in a case.

In the box

  • ›  T11 tester
  • ›  Carry case

Technical data

Battery test12V
Starter motor test12/24V
Alternator test12/24V
Ground test12V
Lead-acid range100-2000 CCA
Lithium range100-2000 CCA
StandardsCCA, BCI, CA, MCA, JIS, DIN, IEC, EN, SAE, GB
PrinterBuilt-in
ConnectivityUSB, QR code
DisplayLCD
Reverse polarity protectionYes
Cable length175 cm
Dimensions230 x 100 x 40 mm
Weight0.72 kg

  • Brand
  • Reference
    TB-LEMANIA-T11
  • MPN
    T11

lemania-t11-ficha-tecnica.pdf

Download (318.49KB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

11 other products in the same category

Viewed products

Loading...
Back to top