• New
GENPRO10X3 NOCO, 3 banks of 10A | telebaterias.com
GENPRO10X3 NOCO, 3 banks of 10A | telebaterias.com
GENPRO10X3 NOCO, 3 banks of 10A | telebaterias.com
GENPRO10X3 NOCO, 3 banks of 10A | telebaterias.com
GENPRO10X3 NOCO, 3 banks of 10A | telebaterias.com

GENPRO10X3 by NOCO: 3-bank on-board charger, 12V 30A (10A per bank)

NOCO

Three good-sized 12 V batteries, each on its own 10 A bank: the GENPRO10X3 reaches 230 Ah per output and is sealed to IP68.

3 banks of 10 A, 30 A in total | Up to 230 Ah per bank | BMS lithium or lead-acid | 450 W, IP68 housing

Free quote, no obligation

Request a quote for your GENPRO10X3 by NOCO: 3-bank on-board charger, 12V 30A (10A per bank)

  • Reply in under 4 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Share

Frequently Asked Questions

insert_link

Buying a battery on telebaterias.com has the following advantages:

  1. First of all, the price. Buying a battery online is much cheaper than buying a battery in a physical store, mainly thanks to our high sales volume.
  2. On the other hand, at telebaterias.com we have commercial agreements with the main battery manufacturers. Thanks to our high turnover, our products are stored for a few days at the factory and reach our customers in the best possible condition. Our batteries therefore have the most recent date of manufacture.
  3. Finally, thanks to our professional technical advice, you can change your battery yourself at the best price
insert_link

To find out if a battery is suitable for my vehicle, the best thing to do is to contrast the characteristics of the battery we have installed with the one we are going to buy.

Battery technology.

First of all, we must check that the type of battery is compatible with the one we are going to buy. If the technology is special, it is usually indicated on the battery. Battery technology is especially relevant in vehicles equipped with a start-stop system.

Measurements.

It is very important that the battery enters the cabin prepared for installation. Keep in mind that the measurements of the batteries are the maximum measurements of the same with all its edges, with the height of the terminal, with the tab for fastening, etc ... Therefore, if you have the appropriate gap for the measurement battery, you will have no problem installing it. In many cases you will see that you have a larger gap to install a larger battery. In these cases, we recommend that you put the battery with the highest amperage that fits into the hole.

Arrangement of the terminals.

It is essential that the positive of the battery matches the location of the positive of the battery you have installed. The convention is to locate the positive being as close as possible to the terminals, since in some cases, the battery may have the terminals closest to the conductor and in other cases closer to the license plate.

However, if you look closely at the photo you can see if the positive of the battery matches the one you have.

In general, except for Asian, American or some off-road vehicles, it is normal for the positive to be on the right.

This is a general guide. However, if you have any questions, contact us and we will be happy to advise you on the most suitable battery for your vehicle.

GENPRO10X3 by NOCO: 3-bank on-board charger, 12V 30A (10A per bank)

What if I have three batteries above 120 Ah on board? That is the GENPRO10X3’s job: 3 isolated 10 A banks (30 A in total), each charging a 12 V battery of up to 230 Ah without one affecting another.

What about cold or heat on the boat? It adjusts the charge to temperature so it does not undercharge in winter or overcharge in summer, and runs from -20 °C to +40 °C. It also flags reverse polarity, a faulty battery and over-voltage. It can stay connected permanently and remembers the last mode on each bank.

Before you order, check

  • ›  All three batteries are 12 V.
  • ›  None exceeds 230 Ah; if they are all 120 Ah or less, the GEN5X3 (3 × 5 A) is more compact.
  • ›  If you have a fourth battery: the GENPRO10X4 adds up to 4 banks of 10 A.
  • ›  There is room for 267 × 188 × 71 mm and 5.81 kg.
  • ›  Call us and we will confirm the model before you place your order.

Features

  • ›  3 isolated, independent 10 A banks (30 A total).
  • ›  12 V batteries up to 230 Ah per bank.
  • ›  Lead-acid (wet, gel, MF, calcium, EFB, AGM) and 12 V lithium with BMS.
  • ›  12V, AGM, lithium, repair and force modes; detects from 1 V.
  • ›  Temperature compensation; operates from -20 °C to +40 °C.
  • ›  Diagnostics for reverse polarity, faulty battery and over-voltage.
  • ›  450 W output; 267 × 188 × 71 mm and 5.81 kg.

In the box

  • ›  GENPRO10X3 on-board charger
  • ›  2 x #8 27 mm self-tapping screws
  • ›  User guide and warranty

Technical data

Mains input voltage100-240 VAC, 50-60 Hz
Output power450 W max.
Charging banks3
Current per bank10 A (12 V)
Total charging current30 A
Battery voltage12 V
Battery chemistriesLead-acid (wet, gel, MF, calcium, EFB, AGM) and 12V lithium with BMS (incl. LiFePO4)
Battery capacityUp to 230 Ah per bank; maintains all battery sizes
Charging modes12V, 12V AGM, 12V Lithium, Repair and Force
Low-voltage detection1 V (Force Mode: 0 V)
Back current drain< 0.5 mA
Operating temperature-20 °C to +40 °C
Housing protectionIP68
CoolingNatural convection
DC cable lengthapprox. 1.83 m
Approx. charging time (50% depth of discharge)20 Ah: 1.5 h · 40 Ah: 3 h · 100 Ah: 7 h · 230 Ah: 17.3 h
Dimensions (L x W x H)267 x 188 x 71 mm
Weight5.81 kg

  • Brand
    NOCO
  • Reference
    TB-NOCO-GENPRO10X3
  • MPN
    GENPRO10X3

noco-genpro10x3-ficha-tecnica.pdf

Download (2.39MB)
Closed prices without surprises with VAT and shipping costs included! (Iberian Peninsula)
Delivery service in 24 hours! Receive your battery comfortably at home
Batteries with the latest date of manufacture

16 other products in the same category

Back to top